Tempered Glass UV-Glue for Samsung Galaxy Note 10 Plus
How to install the uv glass
Step1: Begin by cleaning your screen with wet and dry wips,then removing any dirt from your screen.
Step2: Remove the white cover of the tube,then use a knife or scissor cut a small hole.
Step3: Rotate the small cap of the tube clockwise and the liquid glue will come out automatically,
Make the liquid glue on the screen in a long line (It is recommended that the glue be poured completely. The glue that drops on the screen can't have air bubbles, if there is air bubble, use the needle to pierce the air bubbles).
Step4: Peel off the mask film from the screen protector.
Step5: Place the screen protector on your phone SLOWLY, the glue will spread evenly on the whole screen.
Never use fingers to press the middle of the screen after placing the screen protector.
Never lift the glass as it will be destroyed and will not be able to be used again.
Step6: Use the UV Light to dry the glue,we suggest one place per 1min (Light time: At least 3 minutes, divide the screen into three areas: top, middle and bottom. per partial light 1 minute to make sure the uv glue has dried) You can still adjust the placement of the glass before use the UV-lamp if it's not in best position, if there is glue spilling on the left or right sides,you can use dry paper to absorb the extra glue.
Step7: Clear the screen and turn off the UV-light for reuse.
Package included:
1×Transparent Tempered Screen Protector(Case Friendly)
1×Nano Liquid glue
1×Cleaning Kits
1×Small UV-Light